Power Communication Tech MU81X-IP Especificaciones descargar pdf (Pagina 97)

KVM over IP Module

5.6.5 Reset to Factory Defaults

This function may be used when you forgot the password to log in the IP-KVM.

Note: The unit will reboot after this command. All current settings will be lost.

The following procedures will revert to factory default settings:

1. Connect a RS232 null modem cable from your local console PC to the IP-KVM Serial port.

Configure your terminal emulation program (such as HyperTerminal or PuTTY) to the

following settings: Baudrate 115200, Data/stop bits 8-1, Parity none, Flow control none.

2. Enter the debugging mode via reboot the IP-KVM system and hit the ESC key. There are two

ways to enter the debugging mode:

(a) Power cycle (reboot) the IP-KVM device. Within 2 seconds of booting the IP-KVM, enter

the Esc key a few times to get a => prompt.

(b) Press & hold ESC AND push and release Reset button, and then release ESC in 2 seconds.

The debugging mode window will display as below.

3. Key in “defaults” command and then Enter. The unit will automatically set to factory default

settings and reboot the system.

97 / 110

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 109 110

Sin comentarios

Power Communication Tech MU81X-IP Especificaciones Pagina 97